2017-07-23 Sunday Sync

Date

23 Jul 2017

Item	Who	Notes
Chassis	Matt Suski	New simulations with 1.25" dia tube, 0.035" wall passing. Safety factors much more reasonable (Min FS=2) Want to add gussets to aid with rollover simulations to strengthen critical nodes in rollover New torsion spec is around 30% lower (3600) than the previous simulations with 0.049" wall New weight specification close to 55kg Wanting to step up wall thickness in high-stress areas to increase safety factors in critical areas Will do sequential cleanups of the model to ensure geometry is good to go to VR3 Kickoff for approval to VR3 on Sunday night, will pull parts from model once approved
Aerobody	Former user (Deleted)	Models out to FormaShape for review - hoping to call them early this week for a design review, as well as a rough cost Array spacing fits nicely with current Aerobody spacing Mounting features coming along - still bouncing ideas around but heading in the right direction Matt Suski and Former user (Deleted) to plan out mounting points in the future
Doors/Mounting	Devon Copeland	Some interferences in the top level assembly that need to be cleaned up before chassis kickoff to VR3 Want to weld a plate into the triangle below the top clevises to support the coilover at a more desirable angle FEA tbc to verify new angle doesn't create a total garbage load path Adding one more lower shaft support to the steering assembly Devon Copelandto address the "snake pit" (Steering/pedal area) this week before VR3 kickoff