Rev 10.3

An iteration of tube removal. Instead of removing all 4 pairs of vertical and horizontal spiderweb tubes, only the back 2 pairs were removed. The top case initially failed by ~6 MPa but, if the rear passenger masses are distributed across 2 of the seatbelt mounting tubes instead of the 2 seat tubes, then the max stress drops to ~270 MPa. Unfortunately the front 30 case still failed.

Folder Path:

D:\Users\Roo\Documents\GrabCAD\MSXIV sims\MS-CHASSIS\Spring 2021 Reinforcement Sims

File Name:

October 10_Rev10.3

This project file was created using Rev 10.1 as the base project.

Updates from Rev 10.1:

• The 2 pairs of vertical/horizontal spiderweb tubes at the back of the car were removed.

• Distribute rear passenger masses across seat belt tubes instead of seat tubes.

Open

 

Open

 

 

Combined Loading (Roll-Over) - Incomplete

It is the case with the pucks.

It needs to be setup using previous examples.

Advisor: Jason He

It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.