Rev 9.0
Folder Path:
D:\Users\Roo\Documents\GrabCAD\MSXIV sims\MS-CHASSIS\Spring 2021 Reinforcement Sims
File Name:
September 19_Rev9.0
This project file was created using Rev 7.0 as the base project.
All 4 passenger masses were turned on.
Learning Note
Had difficulty setting up the solids (gussets and sheet metal) which caused solver pivot errors.
Learned that solids need to intersect the beam elements or be very close so that the bonded contacts work properly and solve.
An approximate fix for the back bar case could be to move the collision object close enough so that it intersects the C plane and solve.
Front Bar - Passes
Back Bar (Failed to Compile) - Need to fix
Failed to compile solution.
There were contacts between the collision object and chassis tubes that were marked as red (by the contact tool). These have not yet been resolved.
Side 30 Wall
Side 60 Wall
A Pillar
B Pillar - Passes
C Pillar - Need to fix back tubes
Front 30 Wall
Front 60 Wall
Top 60 Wall
Top
Top 30 Wall
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
It needs to be setup using previous examples.
Advisor: Jason He
It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.