Tie Rod to Centerlink Assembly

Assembly instructions for the tie rod, centerlink assembly and steering arm.

BOM

Number	Part Name	Quantity	Assembly

Number	Part Name	Quantity	Assembly
1	Centerlink Assembly	1	Centerlink Assembly
2	Tie rod Assembly	1	Tie Rod Assembly
3	Steering arm assembly	1	Steering Arm to Upright Assembly
4	2mm ring shim (98089A441)	2
5	M8 x 1.25-35 SHCS	2
6	M8 Nylon Locknut	2

Tie rod to centerlink assembly:

Insert the two ring shims (Part #4) and the tie rod (Part #2) into the centerlink assembly (Part #1) as shown. Ensure that the holes of the centerlink assembly, shims and the tie rod bearing align. Note that the tie rod rests between the 2 shims.

Front view of the assembly. Centerlink assembly is transparent to see the location of the shims.

2. Insert the screw (Part #5) into the hole of #1. Put the nylon nut (Part #6) into the threads of #5 and tighten.

Front view of the tightened screw and nut.

Tie rod to steering arm:

3. Position the steering arm (Part #3) by aligning its hole with the hole of the tie rod bearing.

Top view of the steering arm in position.

4. Insert the screw into the hole of #3. Put the nylon nut onto the threads of #5 and tighten.

Side view of the tightened screw and nut.

5. Repeat on the other side.

Done