Steering Final Checklist

A few tasks are left to finish off the steering system:

• Create a parts finalized version of all of the parts
  
• Shrink tie rod slightly for adjustability
• Tear out checks for clevises
• Check tolerances
• Steering stops
• Try to get a smaller rod end for 40 degrees of rotation (We need 38 degrees as it stands)
• Create drawings for all of the parts

Sunday we should have all of this ready.

Steering Arm Design Notes:

• The mounting face on the upright has a slight angle wrt the right plane; it is rotated about the y axis. The steering arm face that is in contact with the upright has the same angle to accommodate for this.
• The fillet sizes are arbitrary