Wire Guides from Module to AFE

Page to document the construction of the Wire Guides

Requirements

Easy to manufacture
Hold all the AFE boards
Heat set inserts are at the top and on the side are used to hold the modules down and the AFE board in place ( Heat Set Inserts)
The bottom is adhesive

Measurements

Height of the 3D printed part is 67.34 mm
Width of board 0.79mm
top angle 35 degrees
Distance from the sides of the AFE board to the centre of the hole for the heat insert is 3.5mm
The height of the board aka the hypotenuse of the 3D printed part is 70mm
Since the AFE board is not touching the ground, the distance between the ground and the AFE board is 10mm

Rough Sketches