3D Model + Keychain Assembly Instructions

Materials

The box is a small amazon package and has been labeled. Inside you’ll find…

• Small Blue + Orange keychains

  • NOTE: there’s another small bag with fewer cars that have small defects on them (i.e. black marks on the inner part of the catamaran, etc.)

• Clear protection spray

• keychain rings

• Clear 3D model bases

• Rubber pads

• Attachments to connect the 3D models to their bases

Other materials

• Blue Paint → need to buy some

• Syringes → small clear box with syringes above the hardware bench

3D Model Assembly

• Clean out unnecessary filament in the logo on the top of the model

• Remove the filler in the catamaran + wheel slots

• Glue attachments into the holes in the base

• Put some glue into the wheel slots and attach it to the base

• Put 3 rubber pads on the bottom of the base (3, not 4 as there’s a higher risk of the model not sitting flat on a table if there's 4)

3D Keychain Assembly

• Make sure there’s not unnecessary filament (there shouldn’t be but just do a check)

  • Most importantly, check the hole where the keychain ring will be attached

• fill a syringe with blue acrylic paint and fill in the windows and logo on the top

• attach a keychain ring