...
| Chassis Version Number | Person Responsible | Changes made | Front collision | Side collision | Top Collision | Rear Collision | Interesting Images | Comments |
|---|---|---|---|---|---|---|---|---|
| Version 14 | Matt Suski | Tube Sizes Altered (set to 1.050" and 0.0625" thickness) Combine tool utilized | ||||||
| Version 13 | Ritu Shah |
|
|
|  | Max stress is in one corner (top collision), not symmetrical to other side. Suggests that this is an issue with the modeling of tubes rather than structure. Max side = 241 Max top = 316 Rear max = 195 Front max = 95 | ||
| Version 13-2-Copy |
|
|
|
| Tried inserting fillet at front joint but results were worse (i.e. max with fillet ~ 132 MPa). Thus, tried same tests without fillets and achieved lower stress results than in V13. | |||
| V13-3 | Ritu Shah | Removed a bunch of members, adjusted them |  |
|  |
| Results still well below yield after removing members |
