• HW-111 - Getting issue details... STATUS
• Review schematics and complete layout for the PCB

• Minor changes to IO pin outs to only have one motor contactor and one pre-charge circuit

• Attempt to send out for fab by Jan 18

• HW-83 - Getting issue details... STATUS

• Second rev to fix pull ups 

• HW-84 - Getting issue details... STATUS

• Second rev to fix footprints and add LEDs and button pull-ups

• Test charging 

• Ensure that the current hardware setup is reliable 
• Range testing

• Implement a Wifi + LTE based system

• HW-141 - Getting issue details... STATUS

• HW-127 - Getting issue details... STATUS

• Test GPS
• Test SD Card 

• Re-implement switching regulator for better efficiency and less power losses

• HW-87 - Getting issue details... STATUS

• Increase noise immunity on 'Input' of High Side Driver for the kill switch 
• Consider adding measurements for HV isolation? (More complex, nice to have safety feature) 

• HW-157 - Getting issue details... STATUS
• HW-159 - Getting issue details... STATUS
• Test LEDs and LED drivers for brightness, heat, and efficiency
  • Different colours (While, Amber, Red) 
• Talk to other teams about how they meet WSC requirements of having it meet DOT/SAE/ECE 

• FW support for any LED drivers

Jenny X (Unlicensed)

Nita E

• Define camera placements 
• Find cameras
• Design a board to power the Pi Zeros
  • 12 V - 5 V regulator (See Centre Console Board) 
  • No controller board 

Fans

• Board to drive a 12V computer fan 
• Control fan speed (at least 2 speeds, or use a potentiometer?)
• No controller board

• Implement ability to read board and ambient thermistor readings 
• ELEC-587 - Getting issue details... STATUS

• 1 board has been brought up already and smoke tested

• Assist with reading and saving ADC readings

• Validate that charger works according to J1772 protocol
• Charge using a level 2 charger

ELEC-497 - Getting issue details... STATUS

• Check whether version logging is interfering with MCI

ELEC-528 - Getting issue details... STATUS