You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 2
Next »
Dynamics Milestones and Deadlines
Milestone | Owner | Deadline | Status |
|---|
Assemble steering by End of Next Week | | | |
Find Housing (machined by Forest) Carmelli | | | |
Steering - Drill 2 holes in center bar Carmelli
- drill hole in steering arm
- edge find on 2 axis -> plane of welded plates, very tight tolerancing
- get a drill bit for position (get machinist square and make sure
- Jig for weld for centre bar plate Caleb Mengistu
- Chopsticks cut to length
- Control arms need to be grinded a bit (sand down)
- Remove shock, try a bunch of different positions to see if wheel hits control arm at other heights
| | | |
Tie Rod Welding - Call Nate Roberts (nano guy) to approve of design before sending it off to Rob to weld Carmelli
- Reweld tube to master cylinder mount Carmelli
| | | |
RSU - Routing brake lines to brake pedal
- Machine Spacers
- Rear Caliper Mount Redesign
| | | |
Brakes - Brake pedal wobble fix
- Hand lever needs to be put in car @ jaiden cut holes into floor panels
- Routing brake lines to parking brake @ ahnaf
- Parking brake caliper attached to steering arm
- PARKING BRAKE CALIPER REDESIGN
- Shave off part of diameter for pistons so there is more distance between threads
- Bleed brakes, buy brake cables
| | | |
FSU - Plug the UCA/LCA, weld, cut
- Shock clevis Interference
- Cut upright spacer bushings (use calipers to measure, subtract width of a TimKen bearing) Carmelli
| | | |
Wheels - inflate last wheel
- 5th rim? → E3? 5k? pain
| | | |
What interferes when you steer?
Steering:
Questions
Reference materials