Current Status:
The current method of fastening uses adhesive/base studs as seen in the following image
Several base studs are to be placed around the panel where they will slot into mounts placed along the chassis
Chassis mounts design are currently in progress ( Taking into account conflicting mounts as well as roof props )
The general mount design is shown below:
Slot is made to accommodate for panel hinging with moving studs
A general look at the current layout of the mounts (most likely going to change) :
To do List:
sync with roof props to check any any motion conflicts
sync with side panel to resolve top tube conflict ( discussion between DRIs took place, but lead confirmation is needed )
Finalize mount design
Create jigs for welding ( up to change as mount design changes )
Previous Fastening Brainstorming:
Revised Ideas:
Initial Brainstorming: