Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

Proposal 2 - May 6 2020

Design - 3D View

Layout - Wiring

Thoughts / Ideas / Comments / Changes

  1. Fan configuration needs to be finalized - Talk with Jason He about firewall and Former user (Deleted) / Connor Hawkins (Unlicensed) about ventilation ducts.

  2. Maybe want to add

  3. Another fuse had to be added (the orange/black box below the contactors) for a fault condition on discharge relay and discharge resistor.

  4. Wall Sections (blue) and the cutouts need to be updated to provide cleaner wiring routing

  5. Solid regions in the HV section are for power distribution, breaking the HV cables into smaller sections to their relevant components

    1. A custom terminal block with thin sheet steel (or aluminum) and weld studs is proposed for this section. A similar configuration will be used as fuse blocks.

    2. Studs preferred over fasteners since the spring washers and regular washers will not fall off when the fuse / wire is removed.

Proposal 1 - Apr 6 2020

Notes

  • Lower Right will be the Power Selection Board

  • Lower Left will be the HV distribution blocks (that connect all of motors, charger, solar, precharge, and DC-DC together)

  • No labels