Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

This is a brainstorming page for all initial sketches and SolidWorks models for the chassis design. 


ArtistSketchComments
Ron Tsang

Image result for tesla chassis

Lightweight chassis (does not conform completely to aerobody). Composed of just a chassis floor with a roll cage (just enough to mount suspensions and steering).

The aerobody should be structural enough to support itself. If not thin extension members can be implemented from the chassis to help support the aerobody.

No reason for the chassis to be as large as the aerobody.





Imagine the Tesla bottom chassis but with a roll cage.

Angela Chao

Rough Sketch

Rough CAD Outline:


Ritu Shah

Total outline:

Basic outline without cross members:

  • 4 hoops
  • Straight beam at the base (I beam) for support
  • Additional cross beams added to base for mounting points
  • Cross behind driver seating area
  • Triangular beams along sides, except at door area

Matt Suski

-All members triangulated

-7 hoops, one main, front roll hoop rear roll hoop, front wheel and rear wheel hoop, front bulkhead and rear bulkhead

-main hoop is one curved tube, with no bends (recommended by Student Formula Design Teams document)

-Three horizontal beams on the front and back to mount the control arms to

-door would be placed between main hoop and front roll hoop


  • No labels