Page Comparison

Datasheet scavenger hunt. Hint: ctrl + f is your friend!

Question	Answer
What bit in what register should be set on the MCP2515 CAN controller to enable one-shot mode?
In the MCP2515, what are the 3 bytes you’d send over spi if you wanted to write 0x17 to register 0x0f?
What is the digital output code (16 bits) for the MCP3427 when the input voltage is 0
What is the first Opcode byte for to start a conversion on the ADS1259
What is the address (hex) for GPIO in the MCP23008?
What are the fault codes for the LTC6811 when a fault is detected in bits 15-12?

Schematic scavenger hunt. Note: MSXII schematics are used because MSXIV schematics are undergoing constant revision.

Question	Answer
On the

MSXII AFE board temperature mux, how many inputs are there? How many pins are needed to talk to the controller board

MSXIV power select board, what port and pin should be set to what state to shut down the LTC4417?
On the

MSXII

MSXIV pedal board, does the controller board talk to the ADC via SPI, CAN, I2C, or UART?
What communication protocol is used by the MSXIV BMS carrier to communicate with the AFE and current sense board?
What port and pin are used for the MSXIV CAN interrupt for the charger interface board?
What port and pin control the horn in the MSXIV steering wheel board?

How is data transmitted from the MicroSD_Reader to other parts of the telemetry board


What protocol is used by the MSXIV MCI to communicate with the MCP2515? What ports and pins does this use?

Versions Compared