Firmware 103 Datasheet and Schematic Scavenger Hunt
- Jess Douglas Muir (Deactivated)
- Mitchell Langdon Ostler
- Hewitt McGaughey
Datasheet scavenger hunt. Hint: ctrl + f is your friend!
Question | Answer |
|---|---|
What bit in what register should be set on the MCP2515 CAN controller to enable one-shot mode? |
|
In the MCP2515, what are the 3 bytes you’d send over spi if you wanted to write 0x17 to register 0x0f? |
|
What is the digital output code (16 bits) for the MCP3427 when the input voltage is 0 |
|
What is the first Opcode byte for to start a conversion on the ADS1259 |
|
What is the address (hex) for GPIO in the MCP23008? |
|
What are the fault codes for the LTC6811 when a fault is detected in bits 15-12? |
|
Schematic scavenger hunt.
Question | Answer |
|---|---|
On the MSXIV power select board, what port and pin should be set to what state to shut down the LTC4417? |
|
On the MSXIV pedal board, does the controller board talk to the ADC via SPI, CAN, I2C, or UART? |
|
What communication protocol is used by the MSXIV BMS carrier to communicate with the AFE and current sense board? |
|
What port and pin are used for the MSXIV CAN interrupt for the charger interface board? |
|
What port and pin control the horn in the MSXIV steering wheel board? |
|
What protocol is used by the MSXIV MCI to communicate with the MCP2515? What ports and pins does this use? |
|