Epoxy:
3M structural adhesive left underneath the cabinet (we have 6, we need 2)
The mix ratio is 2:1 and provides 20 minutes of work-life, allowing time to adjust for the desired fit prior to curing. This adhesive reaches handling strength in approximately two hours and is fully cured in 24 hours at 72 °F (22 °C).
To get rid of extra epoxy, heat up a soldering iron up to 150 degrees celcius, then take and use rubbing alcohol and get rid of the epoxy
Make sure the gun matches, push and pull the tabs
Use quadro static mix nozzle (we have 5, we need 2)
It is recommended to use a new tip or mixer nozzle for each cartridge
MAKE SURE TO TILT UPWARDS AND TRY TO GLUE
very viscious
...