This is an iteration of tube removal optimization. The back bar and top 30 case failed, so this could only be pursued if that those collision case is cases are resolved.
| Table of Contents |
|---|
Folder Path:
D:\Users\Roo\Documents\GrabCAD\MSXIV sims\MS-CHASSIS\Spring 2021 Reinforcement Sims
File Name:
October 11_Rev10.5
This project file was created using Rev 10.4 as the base project.
Updates from Rev 10.4:
Removed one pair of rear angled spiderweb tubes and the associated gussets.
Front Bar - PASS
Back Bar - PASS
Side 30 Wall - PASS
Side 60 Wall - PASS
A-Pillar - PASS
B-Pillar - PASS
C-Pillar - PASS
Front 30 Wall - PASS
Front 60 Wall - PASS
Top 60 - PASS
Top 30 - FAIL
Top 30 - PASS
Top - PASS
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
It needs to be setup using previous examples.
Advisor: Jason He
It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.