...
- Install dashboard
- Install EV port charger (will involve removing right aero panel)
- Replace nylon insert nuts connecting aerobody with fujilock nuts
- Install charger enclosure (Eric/Catherine)
- Finish and install parking brake (Shi Jing)
- 3D print c-clamps for attaching internal carbon fibre panels (Catherine)
- Finish wire system to hold down trunk (Sheila)
- Obtain jack (Michael)
- Obtain nylon shear pin (Michael)
- 3D print magnet housing for fairing (Michael)
- Create locking trunk props (Emily)
- Remove right motor from MSXII (Michael)
- Debug motor for issues (Shalin)
- Polish windshield and apply both cleaner and RainX
We did hit a bit of a snag with two of our motors going out of commission. During track day, one of the motors crapped out and we replaced the third motor hall sensors before putting that motor back on the car. Unfortunately, that died too so we're down to one motor. Motors are pretty critical for comp. So that has to be done asap.
...