Page Comparison

Summary: Got bodied but tight deadlines before manufacturing can proceed

Module

• add ribs to the L bracket of the module holder

• Make into one part

• Vertical mounts - make sure there is enough space/strong for heat insert

• Test the module to module connections

• Shift the hole to eliminate filetdivet in plate

Cell Holder

• ABS → look into printing services (Micheal, WatIMake)

Busbars

• Only have sigma clad for module to module connections

  • Nickel to nickel for parallel + series connections

  • Due to spot-welding limitations

• Conduct resistivity test of connections

Module to Enclosure Design

• M3 socket hex Hex caps will MAY interfere with one another

• M3 may be too weak

• Find hardware to fit

Module to AFE

• Highest temp will be in the center

• Change number of thermistors to 24 → change layout

Manufacturing

• Test material resistivity

• No thermal test

• Need a way to measure ambient temperature (post manufacturing)

  • Start Strat will need this data

Electrical Connections

• Figure out a way, low prio, copper bar works for now