...
Question | Answer | |
|---|---|---|
What bit in what register should be set on the MCP2515 CAN controller to enable one-shot mode? | a | |
In the MCP2515, what are the 3 bytes you’d send over spi if you wanted to write 0x17 to register 0x0f? | ||
What is the digital output code (16 bits) for the MCP3427 when the input voltage is 0 | ||
What is the first Opcode byte for to start a conversion on the ADS1259 | ||
What is the address (hex) for GPIO in the MCP23008? | ||
What are the fault codes for the when a fault is detected in bits 15-12 LTC6811? |
...