Previous Fastening Brainstorming:

• Revised Ideas:

• Initial Brainstorming:

• The current method of fastening uses adhesive/base studs as seen in the following image

Image Modified

• Several base studs are to be placed around the panel where they will slot into mounts placed along the chassis

• Chassis mounts design are currently in progress ( Taking into account conflicting mounts as well as roof props )

• The general mount design is shown below:

Image Modified

• Slot is made to accommodate for panel hinging with moving studs

• A general look at the current layout of the mounts (most likely going to change) :

Image Modified

To do List:

• sync with roof props to check any any motion conflicts

• sync with side panel to resolve top tube conflict ( discussion between DRIs took place, but lead confirmation is needed )

• Finalize mount design

• Create jigs for welding ( up to change as mount design changes )