...
The idea behind this design is to create a “tray” (Fig. 1) to constrain movement in the outer edges of the specimens. Multiple specimens can be cured at the same time in this tray. The spaces between each individual specimen will be separated with skewers ladder-shaped 3D printed jigs (Fig. 2) as well as the spaces between each adhesive joint on a specimen (Fig. 3). A flat board/weights will be placed on top of all specimens to add pressure. Each ladder
Fig. 1
The equation shown in Fig. 1 is used to determine the length dimension of the tray. “n” is the number of specimens that the tray would be manufactured to hold. For example, if the tray is to hold 5 specimens (n=5), then the resulting dimension would be 25*5 + 50*(5-1) = 325mm.
Fig. 2
Fig. 3
...
...
Figure 2, seen below, is a side view of three separate test specimens. This is how they will be aligned in the jig.
Fig. 2
Figure 3 is an example of how the jig will clamp the test specimen. The green planks are aligned as seen in Figure 32. A flat board should be placed on the ground first and then the specimens should be placed on top of it. Then, a flat board (like a piece of plywood for example) will be placed on top of the specimens and weights will be placed on top of the board to apply downwards pressure on the z axis (purple). There will be four longer boards, two per axis, that run parallel with the sides of the specimens on the x and y axis. These boards are in place so that pipe clamps can apply pressure from the sides (red). The idea is that the ladderblue square-shaped pieces will ensure that the test pieces line up properly under clamping force. It is possible that more ladder thin brown square pieces may need to be added in the middle section. Many Nine of these specimens can be lined up at once , basically the limit is the length that the pipe clamp can reach.
...
inside of this tray.
...
Fig. 43
Adhesive Anti-Sticking Solution
...