Abstract/Summary
This section will include the following (and maybe some other stuff I missed?)
Highlight of results
What test we are doing (tensile, compression anvil pendulum etc.)
Some more specific information we missed, for example, we used our own equipment, we didn’t have the correct equipment so we had to choose something else, something that may have messed up our test results? (feel free to add other things you believe are important to note)
Lack of test specimens for the standard quantity that standards require?
Link to ASTM Standard summary?
Introduction
Here, outline a more thorough explanation of the test we are doing, explain why we are doing the test for context, what are we aiming to get out of it?
Add the composite failure modes we are expecting
Add what results we will believe should be relevant
Materials
Equipment required
*name of equipment with description?*
*picture of equipment?*
*name of equipment with description?*
*picture of equipment?*
*Keep going with however much equipment required*
Procedures
Apparatus
Here, I was thinking we could just give a short description of the whole setup and then a picture of the exact one we used during the test?
Test Specimen
prepPrep
Here, we can outline how we prepared the specimen along with the dimensions we went with, sorta similar to what Tommy did here in the specimen prep section:F2020 - Bottom Panel Structural Evaluation?
Raw DataPreliminary calculations
In this section we will include the following:
The first test here will be used to list variables that were recorded specifically for this experiment similar to what Tommy did here in the results section:F2020 - Bottom Panel Structural Evaluation
Variable | *Value obtained with unit* | *any notes on it* |
|---|---|---|
In the following table, record the actual measurements obtained for what was listed above ^^.
Specimen Number | *Value obtained with unit* | *Value obtained with unit* |
|---|---|---|
Raw Data
Results obtained directly from the test and maybe pictures of failure modes?
Specimen Number | *Value obtained with unit* | *Value obtained with unit* |
|---|---|---|
*Name and description of why failure mode occurred*
*picture of failure mode in question*
Processed Data
Here, will include calculations we do after the test.
Specimen Number | *Calculated property value with unit* | *Calculated property value with unit* | *Calculated property value with unit* |
|---|---|---|---|
We can continue with another table or just add cells to the end of this table?
Graphs below this with a description of what the graph is showing
Discussion
Here, we can just explain what went/think went wrong and how we could’ve maybe avoided it if anybody wants to read this for future reference?
Conclusion
Here, we can include our final remarks and what we learned while going through this test
Validity of results
Conclusions
Implications
Some Highlight of Results (quantitative statements)
Trends
More stuff that I can’t think of?