Elec Onsite Fall 21

Sept 20

Aashmika + Jess

POWER SELECT

• couldn't repro issue with shdn pin line 287 power_select.c turning the board off briefly (0.5 seconds)

• started checking valid pin readings and they were broken

• checked continuity for all the valid pins + resistors and everything looked fine (no shorts)

• was a bit discontinuous with the controller board plug, resoldered

• valid pins worked after resoldering! note: valid pins are active-low, should change code to reflect that

• voltage reading is consistently wrong but some are more correct than others, hardware to debug vsense pins

• isense are all wrong, scaling factors seem off

babydriver snippet for checking valid pins:
def read_pins():
print('a8', gpio_get('a', 8))
print('a9', gpio_get('a', 9))
print('a10', gpio_get('a', 10))