Datasheet scavenger hunt. Hint: ctrl + f is your friend!
Question | Answer |
|---|---|
What bit in what register should be set on the MCP2515 CAN controller to enable one-shot mode? | |
In the MCP2515, what are the 3 bytes you’d send over spi if you wanted to write 0x17 to register 0x0f? | |
Why is the digital output code (16 bits) for the MCP3427 when the input voltage is 0 | |
What is the first Opcode byte for to start a conversion on the ADS1259 | |
What is the address (hex) for GPIO in the MCP23008? | |
What are the fault codes for the when a fault is detected in bits 15-12 LTC6811? |
Schematic scavenger hunt. Note: MSXII schematics are used because MSXIV schematics are undergoing constant revision.
Question | Answer |
|---|---|
On the MSXII AFE board temperature mux, how many inputs are there? How many pins are needed to talk to the controller board? | |
On the MSXII pedal board, does the controller board talk to the ADC via SPI, CAN, I2C, or UART? | |
What communication protocol is used by the BMS carrier to communicate with the AFE and current sense board? | |
What port and pin are used for the CAN interrupt for the charger interface board? | |
What port and pin control the horn in the steering wheel board? | |
How is data transmitted from the MicroSD_Reader to other parts of the telemetry board? |