This page goes over the different minicom commands and setup
Setup:
Minicom should be already installed. If you get errors saying it isn’t, install it.
Run these commands in the command line in the fwxv repository.
// Run this to get into the minicom set up ~fwxv$ sudo minicom -s -c on
This will bring up a table
Go to Serial Port Setup
Change A - Serial Device to /dev/serial/by-id/
click enter twice to save
click save as dfl
Running minicom:
// Run this to get minicom running ~fwxv$ minicom -D /dev/serial/by-id/[click tab here to fill in with usb device]
This should pop up a screen for minicom where output from the board can be seen.
Exiting minicom:
Click ctr+a, then click x. This should bring up an exit screen.