Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Abstract/Summary

This section will include the following (and maybe some other stuff I missed?)

  • Highlight of results

  • What test we are doing (tensile, compression anvil pendulum etc.)

  • Some more specific information we missed, for example, we used our own equipment, we didn’t have the correct equipment so we had to choose something else, something that may have messed up our test results? (feel free to add other things you believe are important to note)

  • Lack of test specimens for the standard quantity that standards require?

  • Link to ASTM Standard summary?

Introduction

  • Here, outline a more thorough explanation of the test we are doing, explain why we are doing the test for context, what are we aiming to get out of it?

Equipment required

*name of equipment with description?*

*picture of equipment?*

*name of equipment with description?*

*picture of equipment?*

*Keep going with however much equipment required*

Apparatus

Here, I was thinking we could just give a short description of the whole setup and then a picture of the exact one we used during the test?

Specimen prep

Here, we can outline how we prepared the specimen along with the dimensions we went with, sorta similar to what Tommy did here:F2020 - Bottom Panel Structural Evaluation?

Raw Data

In this section we will include the following:

Variable

*Value obtained with unit*

*any notes on it*

  • In the following table, record the actual measurements obtained for what was listed above ^^.

Specimen Number

*Value obtained with unit*

*Value obtained with unit*

  • Results obtained directly from the test and maybe pictures of failure modes?

Specimen Number

*Value obtained with unit*

*Value obtained with unit*

*Name and description of why failure mode occurred*

*picture of failure mode in question*

  • Graphs below this with a description of what the graph is showing?

Processed Data

Here, will include calculations we do after the test.

Specimen Number

*Calculated value with unit*

*Calculated value with unit*

*Calculated value with unit*

We can continue with another table or just add cells to the end of this table?

Discussion

Here, we can just explain what went/think went wrong and how we could’ve maybe avoided it if anybody wants to read this for future reference?

Conclusion

Here, we can include our final remarks and what we learned while going through this test?

  • No labels