For future battery-enclosure panels:
It is better to laminate from downwards-up
Reduces risk for dry-spots - the resin cannot just flow in-accordance to gravity
Depends on the scale of the part
Perforate your core with 1/8” holes spaced around an inch aparthelps the resin flow-through adequately through both-sides
can use school’s CNC machine to program and cut-holes
Always perform a vacuum-drop test before starting infusions
Use breather if-possible to prevent the bag from being punctured
Always add lots of pleats (6” long) to your bag so that every-crevice is covered well with the tape
including at the tubing where the Enka sits
Instead of wrapping the chromate tape around the tubing, stuff the chromate inside, poke a small-hole for the resin to go-through, and then
Calculations for resin:
general rule is to give core a buffer of 10%, and for all-else a buffer of 10%
good to perform a gel-test with a small amount of resin to see how fast gelling occurs - record initial temperature, amount of time which has passed and amount of catalyst-used
learned that you can get-away with a lot less catalyst than you realized
Male versus Female Mold:
Male molds are better for when you want the out-side of your part to look nice, for example for the aero you want the outside of the car to be the “A” side to decrease drag so you use a female-mold