File Version: Beginnings 6.0
Material - 4340 Steel Annealed was used
Error Message: A large displacement error message occurred. Clicked no to continue with the study.
Fixtures
The fixture locations are shown in the screenshot below.
Mesh
Loading Case 1 (total selected for all loading cases - correct if incorrect)
There is a 2096.57y force from the inner hub to the spindle. The loading case and results are shown below.
Loading 2
Outer Hub to the spindle is -6872y, 74.34z
The inner Hub to Spindle is -1080.4 (OMITTED), 9033y, 1006z
(changed to total in sim)
Simulation fail error
Loading Case 3
Please correct if the location of the x-direction load is incorrect,
Outer Hub to spindle: 759x, 4834y, -52.28z
Inner Hub to Spindle: -3314y, 812z
There were NO thread lines on the Solidworks file that was provided. As a result, it was impossible to apply an x-direction load. Not sure if this was a file upload error or an improper upload on my part. See below for more detail I can correct this once a new file is provided or issue fixed.
Loading Case 4
Outer Hub to Spindle: -8786y, 95z
Inner Hub to Spindle: -1381x(OMMIT), 11549y, -1476z
Loading Case 5
Outer hub to spindle: 971x, 6180y, -66z
Inner hub to Spindle: -4237y, -904z
There were NO thread lines on the Solidworks file that was provided. As a result, it was impossible to apply an x-direction load. Not sure if this was a file upload error or an improper upload on my part.
Recommendations
TBD