2021-08-2816 F2021 Electrical Planning

BMS Carrier

• Needs to be tested under previous BMS carrier configuration. Lower priority, focus on solar and charging.

HARDWARE VALIDATION

HIGHESTHIGHMEDIUMLOW

Front/Rear Power

• All smoke tests and interfacing has been done. Need FW project to work and sequencing. Lower priority Front PD to be built (2nd PD board)

FIRMWARE VALIDATION

Power Selection

• Paused validation due to bugs, Nita blocked by school

BLOCKED

Steering

• Need to be tested with steering stalk and clockspring

FIRMWARE VALIDATION

Solar

• Solar testing has been done using the Solar car. Debugging July 17. Need to figure out the MPPT issues and test ideal diode and relay driver

FIRMWARE VALIDATION ELEC INTEGRATION

Charger Interface

• Higher priority > Telemetry. Need to debug the smoketest - not sure about time estimate due to unknown error source. charger testing will determine changes

FIRMWARE VALIDATION

AFEs

• almost done testing, no changes to be made so far. Last thing to do before BPS testing is to test with thermistors

FIRMWARE VALIDATION

Battery Connector Module

• need to test it to make sure fuses blow...

ELEC INTEGRATION

Center Console

• need to test, will check if a new rev is needed

HARDWARE VALIDATION