Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Version History

« Previous Version 3 Next »

Schematic

  • Do NOT match IC pin outs to their physical layout. Instead, put power pins on top, ground on the bottom, inputs on the left and outputs on the right. See here for reasoning.

PCB

  • Pin 1 on all SMT footprints will have rectangular pads, all other pins will have rounded rectangular pads.
  • Pin 1 on all through-hole footprints will have square pads, all other pins will have circular pads.
  • All connectors should have pin 1 on the left.

Connectors

  • Wire-to-board signals will use 1.5mm Clik-Mate connectors.
  • Wire-to-board power will use another connector capable of 10A.
  • Panelmount connectors will use a sealed, locking connector.
  • HV power will use Anderson SB120s.
  • No labels