This page will go over some of the bigger projects that we need to complete this term.

Organization
- Organize IC bin
- Organize heat shrink
- Organize wires - make sure they are labeled, figure out what we need to order
Guides
- Create a wire crimping guide
  - Link to the molex guides, etc
    - MX150L: http://www.literature.molex.com/SQLImages/kelmscott/Molex/PDF_Images/987650-2181.PDF
- Read Motor Controller documentation (Tritium Wavesculptor 22)
  - Understand control loops
  - what settings to change for optimization and troubleshooting
  - inductance requirements
Wiring
- Spec the HV connectors
  - TE connectors similar to Formula Electric?
- Spec LV power and signal wire
  - shielded? pre-twisted pairs?
- Connectors on all wires that need to be removed
  - Create best practices guide
- Figure out car wiring
- Figure out electrical box mounting and positioning
Boards - Testing
- Bring up and Validate All Boards
  - Maintain documentation on what is tested, how it was tested, etc.
Other Testing
- Finish Testing Solar for MPPT Decision
  - Further Nomura Testing
  - Reverse Engineer the Nomura Ideal Diodes
- Test Reflow Oven and create optimal profile
  - Reflow Oven
  - Choose new solder if required
- Create 36S 1P test jig for BMS
  - BMS Test Rig
- Create layout for electrical integration testing
  - for full firmware integration testing
  - Do we want this to be separate from out powertrain integration board?
  - Electrical Mock-up of MSXIV

Browser not supported