Interfaces from MSXIV boards.
MSXIV_PedalBoard
Compenent | Required Signal | Testing Board Reqiurement | Notes | ||
|---|---|---|---|---|---|
| 1 | Accelerator Pedal Connector | AIN1_HALL_SNS | Analog Input | DAC | |
| 2 | Steering Angle Sensor | AIN4_STEERING_ANGLE_SENSOR | Analog Input | DAC | |
| 3 | Parking Break Sensor | AIN5_PARKING_BREAK_SENSOR | Analog Input | DAC | |
| 4 | Break Pedal Connector | AIN2_POT1_BREAK | Analog Input | DAC | |
| 5 | TOTAL | 4x(DAC) |
MSXIV_SolarSense_Rev_2
Compenent | Required Signal | Testing Board Reqiurement | Notes | ||
|---|---|---|---|---|---|
| 1 | P3 | PB8_I2C1_SCL PB9_I2C1_SDA | I2C | 3POS HEADR FEMALE 0.1" | |
| 2 | P2 | PB10_I2C2_SCL PB11_I2C2_SDA | I2C | 3POS HEADR FEMALE 0.1" | |
| 3 | MPPT_x (1-6) | (need to come back to it) | |||
| 4 |
MSXIV_BMS_Current_Sense_Rev_3
Compenent | Required Signal | Testing Board Reqiurement | Notes | ||
|---|---|---|---|---|---|
| 1 | 100uOhm Shunt Resistor | R1 (SENSE_2_P/SENSE_N) | Voltage fluctuation | Mimic the 100u shunt? | |
| 2 | R1-3/R1-4 | isoSPI to SPI (with LTC6820 chip) | Molex # MX150 con OR IN and IP holes | ||
| 3 | |||||
| 4 |
MSXIV_BMS_AFE_Rev_2
Compenent | Required Signal | Testing Board Reqiurement | Notes | ||
|---|---|---|---|---|---|
| 1 | THERMISTOR_CELL_x (0-9) | P8 | CONN R/A 12POS 3MM | ||
| 2 | THERMISTOR_CELL_x (10-29) | P7 | CONN R/A 20POS 3MM | ||
| 3 | CELL_INPUT_x (0-12) | P4 | CONN R/A 16POS 3MM | ||
| 4 | BAL_INPUT_x (0-12) | P3 | CONN R/A 14POS 3MM | ||
| 5 | From BMS Carrier | P1 | isoSPI | CONN 2POS DURA-CLIK 0.079" | |
| 6 | To next AFE | P2 | isoSPI | CONN 2POS DURA-CLIK 0.079" | |
| 7 |
MSXIV_BMS_Carrier_Board_Rev_2.1
Compenent | Required Signal | Testing Board Reqiurement | Notes | ||
|---|---|---|---|---|---|
| 1 | |||||
| 2 | |||||
| 3 | |||||
| 4 |
-UV cutoff
-Controller Board
-Centre Console
-Steering Interface
-Power Distribution
-Power Select