KITS! First layer bridging can be significantly reduced if we do the first layer in small pieces, we just need to “hide” the seams in a clever way. Multimatic usually does this by hiding seams on corners and bends, since the light already bends there so it's harder to see it.
The release film is crucial for keeping resin content
when bagging, set your perimeter, plan your pleats, and then beg everything but the pleats
debulk the layup after core to ensure it sticks down.
for “gaps” in the core (as present in the A-bulkhead), we can add strips of carbon to “round out” and fill those gaps
Use wax instead, 6 coats. If we keep using frekote, then seal the sanded surface first and then add the release, 1 layer of mold sealer to seal everything before mold release
Use the better inlets, buy vacometer???
Spraytac carbon fiber for infusion to conform it to the mold, make it easier to work with
Wider vacuum bags are available (so we dont need to envelope)
General
Content
Integrations