Assembly instructions for the steering column lower bearing plate to the chassis.
BOM
Part Number | Description | Quantity |
|---|---|---|
1 | Chassis | 1 |
2 | 3/4”-16 RH Rod End | 1 |
3 | Bearing Plate Lower | 1 |
4 | 3/4”-16 Nut | 1 |
5 | M8x1.25-45 SHCS | 2 |
6 | M8 Flex Top Locknut | 2 |
Instructions
Place the bearing plate lower (Part #3) on the chassis (Part #1) such that the 2 holes of #3 are aligned with the 2 holes of #1.
2. Insert the 2 screws (Part #5) into the holes of # 3. Thread the 2 nuts (Part #6) onto the screws and tighten.
Sectional view of the tightened nuts and screws. Chassis is transparent
3. Insert the rod end (Part #2) into the central hole of #3. Position it such that the start of the shank of the rod end is flush with the top surface of #3, as shown. In this position, no threads of the rod end should be visible when looking at the top surface of #3.
4. Put the 3/4” nut (Part #4) onto the threads of #2 until the nut hits #3. Do not tighten.
Front view of the rod end and the nut
Done 