Raiding the Bay

We need to figure out the following:

• What boards we want to send out, receive, assemble and validate

• Who has time and resources next term for the above^

• What resources can liam/josh? take from the bay

Our primary goal for the spring 2020 term is to validate and test every board as well as to have well defined and documented testing procedures to make testing and validation of new boards and rev a breeze in the fall.

Tools/Equipment

1. Fluke Multimeter (Yellow) and test probes

2. Agilent Multimeter (Orange) and test probes

   1. Thermocouples?

3. Keysight 34410A 6.5 digit benchtop DMM

4. Reflow Oven (if possible)

   1. Solder paste, mini fridge, scraper, etc if possible

5. Heat gun for rework

   1. Kapton Tape could help as well

6. Soldering iron

   1. Solder, flux as well

7. Power Supplies

   1. There is an Agilent one on the battery testing bench (not the high voltage one)

   2. There is a large linear one under the electrical bench

8. Microscope if someone is willing to take care of it, and if they let us.

Boards/Components

1. Controller Boards, parts, and stencils, we should have parts or 30.

   1. The rev from JLC PCB with the pick and place panel

2. The rest of the board boxes above the electrical bench

3. Resistor/capacitor/IC boxes could save us money from having to buy them