Page Comparison

...

...

1. Rod end assemblyends:
   Put #4 onto the threads of #2 with the flat side facing away from the bearing. Twist the nut till approx 14mm from the end of the thread, do not tighten.
   

   Image Added

   Image Added

2. Thread the rod end onto #3, adjust the #2,4 and 3 until there is one thread to the left of the nut, then tighten the nut onto the tube side (highlighted). Repeat this for the other tie rod.
   

   Image RemovedImage Added

   Image RemovedImage Added

3. Follow the Tube assembly:
   Weld (welding is usually outsourced to someone who can weld, ask DRI about welding) #3 to #1 on both sides with inserting the smaller diameter side of #3 into the tubeEnd Welding Jig assembly instructions to weld the tube to the rod ends.

   Repeat steps 3 and 4 for the other rod end assembly from step 1.

   1. The highlighted faces are to be welded.

      

   2. The #1 is transparent to show the welded assembly.

      Image Removed

4. Put the rod end assembly from step 1 and the tube assembly from step 2 together by inserting the rod end into threads of #3.

   Image Removed

5. Adjust the rod end, nut, and tube until there is one thread to the left of the nut, then tighten the nut onto the tube side (highlighted).

   Image Removed

6. 1. Image Added

7. Repeat for one more tie rod