Questions for Adrian Au:
1 - Extending the camera enclosure to allow for panel mount connectors (to keep everything watertight, especially in the back area near the seam of the car). And how do we wire up said connectors to the camera itself - are there solder pads to break out wires from?
2 - What are we doing about the batteries in the cameras? We should double-check their use against the regulations, or if we just have to power everything off of the main 5V rail (which we will connect for charging anyways, but should verify with regs.
3 - Not pertaining to Cameras, but we’ll keep them all in 1 place. Where is the front killswitch being mounted (both the interior and exterior ones).
4 - Will the front electrical enclosure be contained in the dash panel, or will all the electrical components on the dash panel - killswitch, fans , PRND switches, monitor, etc. not be mounted to the carbon fiber panel?
Protecting the video quality of the cameras is very important, as we are modifying the cameras to connect to an external display, over a long distance (4m ish for the rear camera).
...