Trying to remove all added gussets.
This is an iteration of optimization focusing on the sheet metal. The change was very minor, just cutting down the width of the sheet metal reinforcement. The length of the sheet metal has already been experimented with a little bit in Rev 9 models.
Another idea for future reductions to the amount of sheet metal needed would be to cut the sheet metal down into individual gussets for each joint. Or possibly cut the sheet metal into 2 long strips to remove some material from the center of the sheet metal.
| Table of Contents |
|---|
Folder Path:
D:\Users\Roo\Documents\GrabCAD\MSXIV sims\MS-CHASSIS\Spring 2021 Reinforcement Sims
File Name:
October 13_Rev10.6
This project file was created using Rev 10.4.1 as the base project.
Updates from Rev 10.1:
The sheet metal width was reduced so that it was about as wide as the catamaran tubes.
Front Bar - PASS
Back Bar - PASS
Side 30 Wall - PASS
Side 60 Wall -
PASSFAIL
A-Pillar -
PASSFAIL
B-Pillar - PASS
C-Pillar - PASS
Front 30 Wall - PASS
Front 60 Wall - PASS
Top 60 - PASS
Top 30 - PASS
Top -
PASSFAIL
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
It needs to be setup using previous examples.
Advisor: Jason He
It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.