...
September 11_Rev7.0_2 Seater + Spiderweb
This project file was created using Rev 5.1 as the base project.
All 4 passenger masses were turned on.
2 Seater + Spiderweb
Front Bar
...
Side 30 Wall
...
Side 60 Wall
...
A Pillar
...
B Pillar
...
C Pillar
...
Front 30 Wall
...
Front 60 Wall
...
Top 60 Wall
...
Top
...
Top 30 Wall
...
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
It needs to be setup using previous examples.
Advisor: Jason He
It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.
Spiderweb
Generate results only if the 2 Seater + Spiderweb configuration passes
Front Bar
Back Bar (Failed to Compile)
Failed to compile solution.
There were contacts between the collision object and chassis tubes that were marked as red (by the contact tool). These have not yet been resolved.
Side 30 Wall
Side 60 Wall
A Pillar
B Pillar
C Pillar
Front 30 Wall
Front 60 Wall
Top 60 Wall
Top
Top 30 Wall
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
It needs to be setup using previous examples.
Advisor: Jason He
It is slightly lower priority because the combined loading condition could be interpreted as an average of multiple cases listed above.
2 Seater
Generate results only if the Spiderweb configuration passes
Front Bar
Back Bar (Failed to Compile)
Failed to compile solution.
There were contacts between the collision object and chassis tubes that were marked as red (by the contact tool). These have not yet been resolved.
Side 30 Wall
Side 60 Wall
A Pillar
B Pillar
C Pillar
Front 30 Wall
Front 60 Wall
Top 60 Wall
Top
...
Top 60 Wall
...
Top
...
Top 30 Wall
...
Combined Loading (Roll-Over) - Incomplete
It is the case with the pucks.
...