...
Solidworks parts are to be named MSMS#####-#####-ShortDescription where #### is the part number. Part numbers are tracked here: MSXII Part and Drawing Numbers
If a part contains only sketch geometry or the part will never exist in real life (ex. driver model), name the file MSMSXXXXX-XXXXX-ShortDescription.
Avoid saving any parts in the 10xxx (i.e. 10000-10999) range in the part and drawing number registry. These part numbers are exclusively for fasteners. Custom manufactured parts are numbered 00xxxx.
Fasteners are numbered 10xxxx.
Bushings are numbered 20xxx.
Off the shelf parts are numbered 30xxx.
Fasteners/Hardware
Fasteners should ONLY be in Deveoplment\Fasteners. Fasteners are tracked in the part registry, and EXCLUSIVELY USE part numbers MS10xxx (i.e. MS10000 to MS10999)
...
Washer are to be named MS10xxx-TypeWasherSizeNote (i.e. MS10xxx-LockWasherM8GR12, where note is any special notes such as grade of the washer or any additional notes)
Dynamic Components
This is a unique case where a single "component" is modelled as several "sub components" and turned into an assembly to allow the component to be dynamic in our assemblies (i.e. the coilver, which is purchased as a singular part, is modelled as a strut and damper and assembled to allow the suspension assemblies to be dynamic)
Dynamic assemblies should have their own unique part number pulled from the part registry. Components of dynamic assemblies should be named SNGL-PartName(A - Z), where PartName is the name of the dynamic assembly, and A-Z are alphabetic suffixes that denote subcomponents of the assembly.
Example: the coilover is saved as MS00045-Coilover, and the damper and strut are saved as SNGL-CoiloverA and SNGL-CoiloverB
Solidworks Drawing
Solidworks drawings are to be named DWG-#####-ShortDescription where #### is the drawing named identically to the part/assembly they reference, even those that do not reference a physical Midnight Sun part. Drawings which reference a component with no assigned Midnight Sun part number (i.e. geometry files, driver models, etc.) shall be assigned a VC### drawing number. For all other components, the drawing number in the title block shall be identical to the Midnight Sun part number. Drawing numbers are tracked here: MSXII Part and Drawing Numbers. PDF versions of drawing should only be committed to GrabCAD when the drawing is ready for release and should have the same name with a -R## suffix to indicate the revision number.
...