Page Comparison

...

This document contains the steps for final assembly of the Catamaran Cover (CC). All manufacturing of fibreglass, polycarbonate and 3D printing should be completed before starting assembly.

Note: Due to the compact nature of the catamaran cover, the locations of the internal components have been defined and must be strictly followed to avoid unwanted interference.

Before permanently fastening/epoxying a part, refer to the master CAD assembly to ensure spacing is correct.

•  Outer Enclosure

1. Once all the fibreglass parts have been made, label each part with masking tape.

2. Check to see if sizing is correct and that edges, corners and faces line up as intended.

3. BB & RE Side Walls (Refer to master CAD)

   1. Mark locations of all ribs, cam covers and wall brackets with masking tape.

...

1. BB & RE Bottoms (Refer to master CAD)

   1. Mark locations of all ribs and cam covers with masking tape.

...

•  Lid Latches

...

Set three of the latches to open CCW and the other three to open CW.

...

Secure the latches to the lid with rubber washers on both sides.

1. Latches on the left side of the lid will open CCW.

2. Latches on the right will open CW.

•  Fan Holders

1. Place fan on the base with the intake side angled downwards and align holes.

2. Secure the fan to the base with screws from the underside.

•  Heat Set Mount

1. See instructions on how to properly attach the heat inserts: Heat Set Inserts

•  Mounting to Chassis
•  
•  
•  
•  
•  
•  
•  
•  
•  
•  

3M DP420 Data Sheet: