Versions Compared

Version Old Version 14 New Version Current
Changes made by

Jieun Lee

Jieun Lee

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents

Ownership

...

  • need non conductive material on the inside

  • strength

  • access cover

Battery Box Cover

  • possibility of adding ceramic fibre / ceramic blanket / ceramic paper on the inside to contain heat

  • able to service the battery modules

    • entire area above modules must be open (able to see it ) when cover is open

    • modules will be installed by lowering them vertically into their slots

Rear Electronics cover

  • during egress, this part will be climbed over by someone

    • must be strong to hold people’s weight

  • current goal: separating high voltage and low voltage sections inside rear electronics enclosure

    • there will be two supports inside the cover, running along the length of the catamaran

...

  • access cover needs

    • power supply input

    • AUX battery input

    • USB ports for phone charging

Recap of ASC Battery Enclosure Regulations

Isolation

  • resistance measured between battery terminals and any portion of the solar car chassis shall be greater than the 1MΩ, for applied potential up to 500V

...

  • required to provide impound box that fully contains the battery enclosure

    • box must have provision such that an Officer can secure with a maximum of two locks / seals

    • must be constructed that it does not contain external hardware that can be removed to access the battery box without breaking the seal

Egress Regulation

Performance Requirement

  • shall define primary and secondary direction for egress

    • must be separated by at least 90 degrees and cannot be on the same side of the car

  • able to exit the car unassisted

    • should take no more than 10 sec for occupant’s primary direction and 15 sec for occupant’s secondary direction

...

  • greyish- warm/soft white

  • attach of fabric (grey, or it could be coloured)

    • according to Google fabric materials are:

      • Fabric: 33% nylon, 67% polyester

      • Hydrophobic and antimicrobial coating

      • Polycarbonate (hard plastic)

  • could add colour to fibreglass / or colour it afterward

    • if we are sticking with google home aesthetic, just need to make sure that it look like the white colour they use

    • Image RemovedImage Added

      maybe the first 3 colours? white colour with a tint of grey/beige

...

  • MS fonts, colours,

Access Point

Helping Research – Renzo

Click Bond

Youtube videos