Front Bridge Panel thickness: 6.5 mm

Windshield thickness: 6.35 mm

Hood flange thickness: 6 mm

Front bridge & windshield combined thickness: 12.5 mm = 0.49 inches

Hood flange & windshield combined thickness: 12 mm = 0.47 inches

Side Panel: 1/4”

Dzus Fastener grip length = combined panel thickness + spring height (ranges from 0.15” to 0.175”)

Max grip length required = 0.49” + 0.175” = 0.665”

Min grip length required = 0.47” + 0.15” = 0.62”

Windshield Mounting Methods & Locations

Verification/Rationale for Final Design

As the Quarter Turn Fasteners excel in portability and do not have any significant downsides, they are the most effective solution for windshield panel mounting.

Table 2: Proposed Mounting Locations & Method for the Windshield Panel

Windshield to Hood

Quarter-turn fasteners would be used to fix the windshield to the hood. These fasteners would be mounted along the flange of the hood panel (Figure 1, below). It is suggested that 6 screws be used to support mounting of the windshield to the hood.

Figure 1: Quarter-Turn Fasteners on the Hood

Figure 2: Measuring Guide for Dzus Quarter-turn Fasteners

Length C, grip length = 0.7 inches and diameter of the screw is 5/16 inches (link: https://www.speedwaymotors.com/Self-Ejecting-Quarter-Turn-Fasteners-700-Inch-Grip-Pack-10,29647.html)

Windshield to Front Bridge

Quarter-turn fasteners would be used to fix the windshield to the front bridge. These fasteners would be mounted as pictured (Figure 3, below). It is suggested that 6 screws be used to support mounting of the windshield to the front bridge.

Figure 3: Quarter-turn Fasteners on the Front Bridge

Windshield to Side Panel

Keeping the trend of using 6 fasteners, the fasteners will be spread out evenly across 1158.98 mm.

Therefore, the Quarter-turn Fasteners will be mounted onto the side panel as such:

(Note: the configuration of fasteners is the same on both side panels)*dunno if windshield will lie on top of side panel or under (used to determine assembly plan)