Page Comparison

...

1. Build on top of Micah’s progress and push the limits of module design

2. Make quality documentation

To-do:

1. Verify battery regulations and our pack spec | June 2nd (KOSTUBH)

2. Assemble Hardware Assembly v7 | June 16th

   1. To do list:Materials

      Thermistor placement, quantity (we need to iterate, I don’t think the plan below is good)
      

      1. Find spot welder

      2. Find thermistors + any microcontroller/arduino

         1. Scope out how to connect

         2. Maybe find micahs board

      3. Thermistors on cells → find board to hook up thermistors

      4. Put on the nickel strips

   2. Spot-weld nickel strips

   3. Add voltage taps (figure out how quantity, and where)

      1. on cells for SoC algo testing

      2. on groups for balancing

   4. 2. Find DAQ

   5. DAQ

      1. I/O with PC

      2. header soldering (Donna Kim )

      3. thermistor assembly (Darton Phoebe Luo )

      4. thermistor placement (Module Testing Wiring Schematic - Google Slides

      : need to source all the components listed above

      1. )

   6. Spot-weld nickel strips

3. Testing procedure | June 30th

   DAQ setup

   1. Charge/DIscharge Discharge profiles

4. CAD Module Iteration | July 14th

5. Build v8 | July 21st

6. Test | July 28th

7. TBD

Phoebe’s Ongoing to-do list (in order):

•  Figure out DAQ and thermistor placement
•  Look into how to attach the thermistors
•  Figure out what parameters you want to test
•  Heat on the bus bars

Notes / Documentation:

...