Versions Compared

Version Old Version 1 New Version 2
Changes made by

Liam Hawkins

Liam Hawkins

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Power Validation

  • Check for continuity between 12 V, -12 V, GND, ISO GND, and 5 V (all of these should be isolated from each other).
  • The board can now be powered by connecting a power supply set to 12 V between 12 V and GND.
  • Measure the voltage between the isolated 12 V and ISO GND, and 5 V and ISO GND.

Current Sense Output

  • Measure the reference voltage by probing the testpoint near the center of the board labelled VREF. The value should be about 2.5 V relative to ISO GND.
  • Without the shunt resistor connected, connect a power supply between the positive and negative terminals. Apply a range of voltages across the positive and negative terminals. Measure the voltage between VREF and IN+. The voltage should be 1 V for each 10 mV across the positive and negative terminals. For example, -2 V with -20 mV, 0 V with 0 V, and 2 V with 20 mV.