...
- One of the battery box rails came off on the driver side. We also took off the spring/sleds for ease of removal.
- Missing mounting screws for WaveSculptor 20s
- Verify replaced motor is installed/torqued correctly
- Create PCB mount for Pre-Charge/Motor Interface
- Create PCB mount for Pedal board
- Create PCB mount for steering interface board
- Create PCB mount for new BMS Carrier Board
- Windshield is pretty scratched/dirty. We should consider polishing or replacing this for visibility. Also it's missing a few screws.
- The driver seat is not installed properly and will tilt back when you lean on the back.
- Secure the mount for the brake potentiometer
- Look into a better way to remove wheels
- Fix the sketchy array prop rod ends, which are falling apart
- Steering wheel/column is not mounted properly
- Seems like there might be air in the brake lines? Pedal goes to the bottom pretty easily.
- There’s a clicking noise on the right front tire. Investigate this further.
...