Versions Compared

Version Old Version 11 New Version 12
Changes made by

Titus Chow

Titus Chow

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  •  Through-holes still need to be widened
  •  The C6 inputs on both connectors should be fused or one should be removed - I recommend removing one and switching to a 6-pin duraclik to prevent plugging in harnesses the wrong way
  •  Still need to use smaller analog mux
  •  Look into removing isoSPI + regulator and just putting an isolated controller board on each AFE ICMP and IBIAS pins are flipped ? - Should be IBIAS → resistor → ICMP → resistor → GND?

Carrier

Revision 1  

...

  •  isoSPI Mode 0 by default (for current sense)
  •  Add connector for kill switch
  •  Add ability to switch between master/slave and modes on isoSPI so we can use it as a sniffer
  •  Bias resistors are flipped and are odd values - should be the same as AFE