...
- Remove R55, R56 - the PowerPath has them pulled high internally
- Fix silkscreen? Taiping Li
- QFN fets are good, they can probably handle up to 8A continuous without heating up too much
- The dual p-fets had an abnormally high rds(on) - paralleling two helped, but still unsure why it happened: got very hot
- Look into replacing them with flat-pack for better thermals (Taiping Li: Please link)
- Automotive fuses have some resistance across them, but it's reasonable for the currents we're expecting.
- Might want to run power as 18 or 16 awg to minimize losses since we're potentially looking at around 2m cables with multiple sets of connectors
- Paralleled n-fets seemed to work - needed to redo one
- We can actually apply the solder paste by hand
- Might want to add some thermistors on the board near fets
- Debug LEDs are connected to output fets - pins should be switched