...
To ensure consistency across mechanical team projects, please read over this page and follow the practices when you are using Solidworksworking with the mechanical team!
1. Coordinate Convention
planes and where the origin will be placed
When symmetric, sketch on which half of the car
FOR HIGH-LEVEL ASSEMBLIES OR PARTS DIRECTLY RELATED TO LOCATIONS IN THE OCCUPANT SPACE:
USE THE DEFAULT SOLIDWORKS COORDINATE CONVENTION
THE ORIGIN PLACED ON THE FLOOR WHERE THE CENTER AXIS INTERSECTS THE FRONT PLANE OF THE CAR
| Expand | ||
|---|---|---|
| ||
A high-level assembly means that the assembly’s position ultimately determines the position of many related subsystems of the car.
|
This means
Origin on the floor, intersecting the centre axis at the front plane of the vehicle (circled below in the occupant space definition diagram)
positive z-axis pointing to the front of the car
positive y-axis pointing to the top of the car
positive x-axis pointing to the left of the car
...
Of course, for parts that are not directly related to positions inside the occupant space - the origin does not have to be positioned as mentioned above.
ex. The steering wheel does not have to follow the origin since it is not directly related to the position in the car
It is related to the position of the stalk → the rack and pinion → the overall dynamics high-level assembly (which is eventually related to the position in the car)
If you are unsure/need clarification - ask a lead to confirm!
If your design is symmetric on both halves of the car - design on the “left” side of the car (where x is positive). Keeping more things consistent across teams is always beneficial.
2. Design Units
Design the car in metric, the only exception being critical fasteners in imperial. Normal fasteners can be metric or imperial, but consult your team lead and keep it consistent.
...
Critical Fasteners: Fasteners for critical areas, which is defined to include: steering, braking, suspension, seat mounts, safety harness, drive train, battery box, ballast carrier, and parking brake.
3. Hole Wizard
Use Hole Wizard when placing holes in your components.
Using hole wizard is an efficient way to place holes in your parts while making sure that hole sizes remain consistent across the whole team.
4. Design
...
Library and
...
Templates
All mechanical components (ex. fasteners, nuts, washers) models should be taken from McMaster-Carr, NOT the Solidworks design library.
When using off-the-shelf (OTS) mechanical components, these are usually purchased through McMaster-Carr Website: https://www.mcmaster.com/
Check the Bild PDM if the component is in our
...
design library and import the model into your assembly.
If the model is not available, download the CAD from the McMaster-Carr website, and add the part in our bild PDM in the appropriate directory under a consistent naming convention.
...
Where to find design library in bild
where to download from mmc
Bild PDM Organization
how to check in check out
...
| Expand | ||
|---|---|---|
| ||
MMC basically has all the mechanical components you need for your design - once you find the appropriate component, click on the part number, and select 3-D Solidworks to download the CAD file for your component.  |
5. Bild PDM (Project Data Management)
Review the link above on how to use Bild as our PDM system to store all our CAD
All MS16 CAD should be stored in the Bild PDM to be accessible to everyone on the team and for version control.
Do not make changes to the top level assembly of each sub
TOP LEVEL ASSEMBLIES
6. Jira: Project Management
Track Projects on Jira